Gammon Forum : Forum : Problems : (Not Working ) Nucleo F767ZI communication Modbus RS 485 Using Max 485 Module

Entire forum ➜ Forum ➜ Problems ➜ (Not Working ) Nucleo F767ZI communication Modbus RS 485 Using Max 485 Module

(Not Working ) Nucleo F767ZI communication Modbus RS 485 Using Max 485 Module

It is now over 60 days since the last post. This thread is closed. Refresh page

Posted by

Kalai (1 post) Bio

Date

Mon 29 Jul 2024 05:32 AM (UTC)

Amended on Mon 29 Jul 2024 05:53 AM (UTC) by Kalai

Message

Hi i am New for Arm mbed ,MY project is i want to Control 3 phase induction motor speed using VFD
Here my inovance VFD controlling by (RS 485 Communication Using Max 485 Module) STM 32 Nucleo F767ZI controller,

My slave ID -01,
Baud rate -9600.
modbus data format -8-N-2,

All my VFD Setting was done and Cross checked by USB to RS 485 Driver using modbuspoll Software.(Here i controlling Motor Speed and Direction)

my connection max 485 drive
Nucleo PD_6 (RX)->RO
RE and DE short connect Digital pin PC_8
Nucleo PD_5 (Tx)->DI

VCC connect 5V power supply
A connect VFD 485+
B connect VFD 485-
Gnd connect with GND

this photo is MY VFD Setting
IMG20240724184108

1920×2560 338 KB
Below i Attached my code

Top

Posted by

Nick Gammon Australia (23,070 posts) Bio Forum Administrator

Date

Reply #1 on Mon 29 Jul 2024 08:20 PM (UTC)

Message

Please post Arduino-related questions to the Arduino Forum or to StackExchange: Arduino. This saves splitting questions and answers between this forum and the Arduino ones.

- Nick Gammon

www.gammon.com.au, www.mushclient.com

Top

The dates and times for posts above are shown in Universal Co-ordinated Time (UTC).

To show them in your local time you can join the forum, and then set the 'time correction' field in your profile to the number of hours difference between your location and UTC time.

699 views.

It is now over 60 days since the last post. This thread is closed. Refresh page

Go to topic: Search the forum

top